Xerox QLS-8100XE Manual de usuario descargar pdf (Pagina 37)

QLS-8100 Xe 3-5

3 Flip the Drive Roller Lift Lever clockwise to open the drive roller.

4 Remove the Media Retainer from the media supply mandrel by first

loosening the small nylon retaining screw then sliding the Media

Retainer away from the printer and off the mandrel.

5 Orient the roll so that the labels are coming off the top and to the right.

Using the media retainer to push the roll, slide the roll onto the mandrel

until it is firmly seated against the back plate. You will feel resistance as

the spring clip on the mandrel secures the roll.

Note: If the media is not fully seated against the back plate, an unprinted

vertical area or void will appear on the printed label.

6 Ensure that the Media Retainer is firmly against the media roll and hand-

tighten the nylon retaining screw to secure the Media Retainer to the

mandrel.

7 Lift the Media Dancer Arm to the right and upwards to relieve back-

tension on the media supply roll. Unroll approximately a 3-foot length of

media.

8 Thread the media down and to the left, then around the Media Dancer

Arm.

9 Remove the Media Guide Collar from the lower Media Guide Roller.

10 Continue to thread the media over and around the Upper Media Guide

Roller then under and around the Lower Media Guide Roller.

11 Thread the media through the Media Sensor Assembly and then through

the Media Travel Roller assembly.

1 2 ... 32 33 34 35 36 37 38 39 40 41 42 ... 184 185

Sin comentarios

Xerox QLS-8100XE Manual de usuario Pagina 37