Xerox Printer FS 3270 Manual de usuario descargar pdf (Pagina 10)

Connecting to System

Xerox FS 3270, User's Guide

- 10 -

2. Installation and Connections of the

Xerox FS 3270

This chapter starts with an overview of the functionality of the rear panel.

Then follows a description of how you connect the Xerox FS 3270 box to

the printer and the system.

NOTE:

Before you start the installation, make sure that you

set the rotary switch at the required emulation. See

SWITCH B/A/T in section 2.1. below.

2.1. The Rear Panel

RS232

12-18 VDC.

0.7A

PARALLEL IN PARALLEL OUTTEST

+ --

A = PCL B = FSL (default)

Fig 2-1 Xerox FS 3270 Rear Panel

COAX

The coax cable is connected to the host which communicates in

accordance with the 3270 protocol.

PARALLEL OUT

The parallel output port is connected to the parallel/Centronics input port

on the target printer (standard parallel out cable supplied with printer

should be used).

PARALLEL IN

The parallel input port can be connected to the parallel/Centronics output

on a PC or similar source able to share the printer with the host. For this

connection you need a spare part cable ending in a 25-pole D-Sub

connector (i-data order no. 999022-030).

ROTARY (TEST) SWITCH

Testing and emulation switch which is read at power-up. Default

emulation is PCL (A).

PCL printer driver = A position. (Default is outside of B, A & T position)

FSL printer driver = B position.

1 2 ... 5 6 7 8 9 10 11 12 13 14 15 ... 61 62

Sin comentarios

Xerox Printer FS 3270 Manual de usuario Pagina 10