Xerox Printer FS 5250 IPC Manual de usuario descargar pdf (Pagina 13)

Connections and Installation

Xerox FS 5250, User’s Guide

- 13 -

6. Connections and Installation of

the Xerox FS 5250

This chapter starts with an overview of the functionality of the rear panel.

Then follows a description of how you connect the Xerox FS 5250 box to a

printer and finally how to connect it to a System.

NOTE:

Before you start the installation, make sure that you set the address

switch and the desired emulation. See the description in the section

"Emulation".

6.1. The Rear Panel

RS232

12-18 VDC.

0.7A

PARALLEL IN PARALLEL OUTADDR

+ --

A = PCL, B = XES

Xerox FS 5250 Rear Panel

PARALLEL OUT

The parallel output port can be connected to the parallel/Centronics in put

port on the target printer (parallel out cable is supplied with the kit).

PARALLEL IN

The parallel input port can be connected to the parallel/Centronics out put on

a PC or similar source which enables it to share the printer with the host. For

this connection you need a cable ending in a 25-pole D-Sub connector

(order no. 999022 030).

SERIAL IN/OUT

The serial port can be configured either as input or as output. Default

configuration is input.

1 2 ... 8 9 10 11 12 13 14 15 16 17 18 ... 103 104

Sin comentarios

Xerox Printer FS 5250 IPC Manual de usuario Pagina 13