Xerox DocuTech 128 HighLight Color Guía de instalación descargar pdf (Pagina 35)

DocuTech 128/155/180 HighLight Color Installation Planning Guide 4-7

Prepare for installation

Space requirements - controller

The dimensions for the Controller Stand are 30 inches (76.2 cm)

deep and 30 inches (76.2 cm) wide.

The operator should have 30 inches (76.2 cm) of space to stand

when operating the system from the keyboard.

Bypass transport specifications

The bypass transport option, which enables you to add a third-

party finishing device, is available as an external module for the

DocuTech 128/155/180 HLC printer. This feature is also available

within the Finisher module for the publisher printer configuration.

The bypass transport is installed by your service representative

and remains permanently in place. You should not attempt to

remove or reinstall it. The following is supported by the bypass

transport:

• Paper size and weight: You can use all of the paper sizes

and weights supported by the printer in the bypass transport.

• Sheet exit orientation: 1 to N (the same order in which sheets

are fed from the printer), delivered face down.

• Maximum throughput speed: The bypass transport for the

printer supports throughput speeds of up to 180 ppm (pages

per minute). This rate is based on stocks up to 9 x 14.33

inches (229 x 364 mm) in length.

• Sheet exit height: 34 inches (86 cm) above the floor.

Bypass transport dimensions

The following pages contain information on dimensions, service

access, and the paper path for the Bypass Transport module.

The Bypass Transport is 20.4 inches (518 mm wide) x 28.3 inches

(719 mm) deep x 56.1 inches (1425 mm) high. Maintain the same

service space around the transport as required by the printer.

1 2 ... 30 31 32 33 34 35 36 37 38 39 40 ... 81 82

Sin comentarios

Xerox DocuTech 128 HighLight Color Guía de instalación Pagina 35