Xerox DocuTech 128 HighLight Color Guía de instalación descargar pdf (Pagina 62)

4-34 DocuTech 128/155/180 HighLight Color Installation Planning Guide

Prepare for installation

Heat management

The DocuTech system produces significant amounts of heat when

running in a production environment. The heat produced by the

system must be considered when selecting a suitable location.

Heat management assessment process

Consult the site HVAC engineer or contractor to determine

whether the heat output can be managed by air conditioning at the

site. Consider the following items when assessing the acceptable

environmental operating conditions for the system:

• heat output of the system when in operating mode (32,770

BTU/hour)

• current relative humidity and temperature of the site

• acceptable system environmental requirements

• high outside temperatures

• incoming airflow rate in total cubic feet per minute (CFM)

Heat Vent Kit option for the DT HLC 180

If the customer site in which the production publisher printer will be

located is small and adequate venting is an issue, a heat vent kit is

available for purchase by the customer.

Installed on the IOT, the Heat Vent Kit provides the customer with

the ability to vent the excess heat produced by the printer through

the ceiling.

A Heat Vent Extension Kit is also available and is used to vent

heat from the interposer module.

Both kits are available through CAS and include installation

instructions for the CSE. Also, a kit is available for the 50Hz or 60

Hz configuration.

Item Order Number

IOT Heat Vent Kit 98K06472

Interposer Heat Vent

Extension Kit

98K42600

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 81 82

Sin comentarios

Xerox DocuTech 128 HighLight Color Guía de instalación Pagina 62