Xerox DocuTech 128 HighLight Color Guía de instalación descargar pdf (Pagina 11)

DocuTech 128/155/180 HighLight Color Installation Planning Guide ix

Safety notes

• Any part of the equipment is physically damaged.

• The equipment emits unusual odors, or makes unusual

noises.

NOTE: The only method to remove all power from the printer is to

disconnect the power cable from the electrical outlet. If the cable

is hardwired to the outlet, the switch or breaker must be used to

isolate the power supply from the printer.

Printer - ozone information

This product produces ozone during normal operation. The ozone

produced is dependent on print volume and is heavier than air.

Install the system in a well ventilated room with the minimum cubic

size requirements listed below. Providing the correct

environmental parameters will ensure that the concentration levels

meet safe limits. The minimum cubic volume requirement is: 1,765

cubic feet (50 cubic meters).

To determine if the room has the required volume to meet the

ozone requirement, the length of the room multiplied by its width

and height should be equal to or greater than the cubic volume

listed above. If you need additional information about ozone,

please request the Xerox publication Facts About Ozone (part

number 601P64653) by calling 1-800-828-6571 in the United

States and Canada. In Xerox Europe countries and DMO, call the

local welcome centre.

Printer - laser safety

CAUTION: The use of controls, adjustments or performance of

procedures other than those specified in this guide may result in

hazardous light exposure.

This equipment complies with international safety standards and

is certified as a Class 1 Laser Product. The laser danger labels on

the system are for Xerox service representatives and are on or

near panels or shields that must be removed with a tool. With

specific regard to lasers, the equipment complies with laser

product performance standards set by governmental, national,

and international agencies as a Class 1 Laser Product. It does not

emit hazardous light, as the beam is totally enclosed during all

phases of customer operation and maintenance.

1 2 ... 6 7 8 9 10 11 12 13 14 15 16 ... 85 86

Sin comentarios

Xerox DocuTech 128 HighLight Color Guía de instalación Pagina 11