Xerox DocuTech 128 HighLight Color Guía de instalación descargar pdf (Pagina 46)

4-18 DocuTech 128/155/180 HighLight Color Installation Planning Guide

Prepare for installation

Floor leveling

For proper operation, the printer must be level. On floors less than

two degrees out of level, installation personnel use a leveling kit to

level the machine.

NOTE: The printer will not function properly on floors more than

two degrees out of level.

If the floor is more than two degrees out of level, find another

location for the printer.

For your reference, two degrees represents a height discrepancy

of approximately 3.8 inches (9.6 cm) measured at the casters with

the printer tilting from left to right, or approximately 0.7 inches (1.8

cm) with the printer tilting from back to front.

If the printer is to be moved after its initial installation, it is your

responsibility to make sure that the printer can be leveled properly.

It is recommended, however, that Xerox personnel move the

equipment.

Delivery access requirements

It is easy to overlook the path required to move the equipment

from the truck to the operation site. To determine access, ask the

following questions:

• Does the equipment need to go up or down a stairwell? How

wide is the stairwell?

• Do you have an elevator, if the equipment is to be located

above or below the first floor?

• Is the elevator large enough for the equipment?

• How wide are the hallways and doorways?

• Do you have a loading dock or a specific door to which the

equipment should be delivered?

You need to review these issues before or during the site

inspection conducted by your service representative.

The equipment dimensions are specified later in this chapter, so it

is easy to determine whether your hallways and doorways are

wide enough to permit access.

Ia any access width is less than 36 inches (90 cm), the printer

must be disassembled.

1. The Xerox personnel conducting the pre-installation site check

must notify the Rigger with the account name, location, Field

Manager Technical Support (FMTS) name and phone number.

2. The Xerox personnel must also notify the appropriate FMTS

with the Rigger name and phone number.

1 2 ... 41 42 43 44 45 46 47 48 49 50 51 ... 85 86

Sin comentarios

Xerox DocuTech 128 HighLight Color Guía de instalación Pagina 46