Xerox DocuTech 128 HighLight Color Guía de instalación descargar pdf (Pagina 70)

5-2 DocuTech 128/155/180 HighLight Color Installation Planning Guide

Installation

verification, and Xerox applications. You have the general site

responsibility of ensuring that the right personnel, supplies, and

network information are available. At the time of installation, you

should do the following:

• Make sure that your system administrator is available during

the loading of software.

• For software loading purposes, be prepared to provide Xerox

personnel with network information from the pre-installation

worksheets. Refer to the Getting Ready for the FreeFlow Print

Server Installation manual for specifics regarding network

information.

• Designate two client workstations for downloading Xerox client

software if applicable: one for initial system validation and

another for use in operator training provided by your systems

analyst.

• If your system will be connected to an IBM host through a

channel, provide the host channel address, channel unit

address, and data transfer mode.

• If your system will be connected to an IBM host through

Socket TCP/IP, provide the host IP address and port number.

• Check the documentation and software kits with their packing

lists for completeness.

• Load Xerox client software on any additional client

workstations. Remember that you are responsible for

supplying, installing, and maintaining your client workstations

and the Ethernet local area network (LAN) that connects them

with the printing system.

NOTE: Have test jobs ready to run and your operators

available for training.

Defining the printer to the host for IPDS printing

Prior to installation of your printer, your host system must be

configured to communicate with and print on an IPDS system.

This requires defining several printer parameters to your host. The

required information and configuration procedures differ according

to your connectivity type (channel or TCP/IP), and your host and

PSF environment. You will need to provide these parameters to

your Xerox representative on installation day.

1 2 ... 65 66 67 68 69 70 71 72 73 74 75 ... 85 86

Sin comentarios

Xerox DocuTech 128 HighLight Color Guía de instalación Pagina 70