
4-2 DocuTech 128/155/180 HighLight Color Installation Planning Guide
Prepare for installation
• Optional: Printer (HLC module and print engine) + inverter
feeder/stacker + 3 feeder/stackers
• Optional: Printer (HLC module and print engine) + inverter
feeder/stacker + 2 feeder/stackers + bypass transport
NOTE: The maximum number of modules allowed in any of the
configurations is 4.
Measurements and a top-view diagram for each of these
configurations is provided on the following pages.
Printer configuration diagrams
DocuTech 1xx HighLight Color publisher printer
The following provides space requirements for the DocuTech 1xx
HLC production publisher configuration.
Printer with
interposer and
finisher
The individual dimensions of the printer, the interposer and the
finisher modules (installed with all front and rear covers) are as
follows:
* The printer depth without the front and rear covers is 34.8 in
(88.3 cm)
• The space requirements for the print server stand are 30 x 30
in (75 x 75 cm).
• The minimum total space required for this configuration is
293.1 x 142.0 inches (744.5 cm x 360.6 cm), including service
area. Refer to Figure 4-1.
• The total weight of the system is 3724 lbs (1689 kgs).
NOTE: Not included in this weight is the print server stand or
FreeFlow Print Server.
Printer HLC module Interposer Finisher
Width 78 in (198
cm)
23 in (58.4
cm)
46.5 in
(118.1 cm)
56 in (142.2
cm)
Depth 42 in (106.6
cm) *
40 in (101.6
cm)
33 in (83.8
cm)
37.5 in (95.2
cm)
Height 41 in (104
cm)
41 in (104
cm)
49 in (124.4
cm)
48 in (122
cm)
Weight 1580 lbs
(716.6 kgs)
365 lbs
(165.5 kgs)
710 lbs
(322 kgs)
1069 lbs
(485 kgs)
Comentarios a estos manuales